12th
October
2007
Air temperature sensor and vacuum plug..
posted in Preparation |
Remove the air temperature sensor from the air box on your donor engine.
Simply insert into SunSpeed induction pipe.
Installing the vacuum plug
Remove the vacuum elbow from the induction manifold, this is quite difficult to remove and requires some heating with a blow torch, some tapping with a screw driver and pulling with a mole wrench.
To install the plug, pretty straight forward. Insert the plug, cover with some sort of impact resistant material and help it locate with the use of a hammer.
Next, re-fit started and alternator…
This entry was posted
on Friday, October 12th, 2007 at 4:02 pm and is filed under Preparation.
You can follow any responses to this entry through the RSS 2.0 feed.
You can leave a response, or trackback from your own site.