11th
October
2007
Preparing gear selector and gearbox casing..
posted in Preparation |
Cut the gear selector as shown. A Dremmel is very useful at this stage.
Now the scary part. Cutting the gearbox casing. Use a hack saw and tidy up the area with your Dremmel.
Actually this job is pretty straight forward. Now simply remove the 2 remaining engine mount studs.
Next, install intake air temperature sensor and vacuum plug…
This entry was posted
on Thursday, October 11th, 2007 at 2:26 pm and is filed under Preparation.
You can follow any responses to this entry through the RSS 2.0 feed.
You can leave a response, or trackback from your own site.